FlatRoofing
Where Water Can’t Run, Detail Rules
Flat roofs fail at details, not fields — drains, edges, and penetrations. Membrane systems for additions, porch roofs, dormers, and commercial buildings, detailed like they matter.
Before we price Flat Roofing, we look at the decking, step flashing and the starter strip — the details that decide how long the work holds. You get a photographed assessment and a written scope with no obligation, and if the cause traces to a storm we document it for your carrier. Licensed and insured in Ohio, Pennsylvania and New York.
Water damage gets worse every hour — call nowGet Your Flat Roofing Ohio PA NY Quote Online
Flat Roofing Ohio PA NY — priced in writing before we start, no obligation.
- Free, no-obligation written price
- Same-day response — often within the hour
- We document and file your insurance claim
- Licensed & insured, 400+ five-star reviews
What is actually used on a flat roof?
Low-slope roofs use membrane systems rather than shingles: EPDM rubber, TPO, or modified bitumen. Shingles depend on gravity and overlap to shed water, which fails below roughly a two-in-twelve pitch. Membranes seal instead, so on a low-slope roof the seams and terminations are what determine service life. Related: rubber roof repair and commercial roofing & flat roof repair.
“Flat” Means Slow Water, Not No Water
Low-slope roofs hold water longer than shingles ever face, so the membrane is only half the system — tapered drainage, sealed penetrations, and edge terminations are where lifespan lives. We install fully-adhered EPDM and membrane systems on residential low-slope sections (that porch roof, the addition tie-in, the dormer top) and commercial roofs alike, with every penetration flashed like it’s the one that will be tested.
Where Flat Meets Pitched
The most common flat-roof leak we see isn’t on the flat roof — it’s the transition where a porch or addition meets the shingled wall above. Water off the pitched roof hits the membrane at volume and finds any termination shortcut. We detail transitions with proper counter-flashing into the wall, not caulk-and-pray — and repair the ones others detailed the fast way. Aging rubber? See rubber roof repair.
Roofing Work, Documented
Asked On Driveways All Week
How long does an EPDM flat roof last?
Quality fully-adhered EPDM realistically runs 20–30 years when the details are right — drainage and terminations decide which end of that range you get.
My flat roof ponds water — is that a problem?
Ponding past 48 hours accelerates every failure mode. Tapered insulation or drain corrections fix it — and are far cheaper than the premature replacement ponding causes.
Do you do small flat sections or only whole roofs?
Both — a single porch roof or dormer top is a normal job for us, not a nuisance call.
What is the best material for a flat roof?
For most residential low-slope sections, fully-adhered EPDM wins on track record and repairability; TPO competes commercially. The details matter more than the acronym.
How much slope does a flat roof actually have?
Code requires at least a quarter inch per foot of fall — ’flat’ roofs are really low-slope roofs, and drainage design is what makes them work.
How long do flat roofs last compared to shingles?
Comparable when detailed right — quality EPDM runs 20–30 years; drainage and terminations decide the range more than the material.
Can you walk on a flat rubber roof?
For maintenance, yes, with care — membranes tolerate foot traffic but not dropped tools, dragged furniture or gravel underfoot.
Why do flat roofs have gravel on them?
That’s older built-up roofing — ballast and UV protection. Modern membranes replaced the system, and we don’t miss the gravel.
Complete The System
The exterior works as one assembly — these are the pieces that connect to this one.
Yes.
Learn more →Commercial roofs are usually low-slope membrane systems rather than steep-slope shingles,…
Learn more →Water rarely enters directly above the stain.
Learn more →Three-tab shingles are a single flat layer with cutouts creating a…
Learn more →Standing seam metal roofing commonly lasts fifty years or more, compared…
Learn more →Heat cables do not melt an existing ice dam.
Learn more →Flat Roofing Service Areas — Ohio, Pennsylvania & New York
Flat Roofing is available across our licensed service territory in Ohio, Pennsylvania and New York. Find your city below, or call (330) 918-1018.
Ohio
Western Pennsylvania
Buffalo & Western New York
Explore The Rest Of The System
More In This Category
Brands & Partners We Use
Service Categories
About Roof Gutter Now
Flat Section Acting Up?
Free look at the membrane, drainage and transitions — honest verdict in writing.
Free Flat Roofing Ohio PA NY Estimate
Takes about 20 seconds.